Printer Stand
Hi,
I've attached a picture of this IKEA cart I bought to put my Prusa MK3S on..... as you can tell, there's a rather interesting arch in the top (IKEA quality coming thru).
So any thoughts? Suggestions on a better desk /cart that won't break the bank?
Thanks!!
You could plane/sand that one flat or top it with a sheet of ply levelled on flexible filler to take out some resonance.
Cheerio,
RE: Printer Stand
Way too much work for me..... I wonder if there's a desk, like a metal desk that I should be looking to purchase to put my 3D printer on??
RE: Printer Stand
Way too much work for me
??
Order a sheet of 13mm ply ready cut to size and (probably two) tubes of flexible sealant. Squidge sealant over entire surface, place ply on top and add weight, yours, until oozing on all sides, place spirit level on top and selectively squeeze until horizontal. Clean up edges and allow to set.
Cheerio,