Print quality was good, but not any more - Assembly and first prints troubleshooting https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/print-quality-was-good-but-not-any-more/ Prusa3D Forum Discussion Board en-US Wed, 10 Jun 2026 06:29:32 +0000 wpForo 60 RE: Print quality was good, but not any more https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/print-quality-was-good-but-not-any-more/#post-724441 Tue, 15 Oct 2024 03:26:28 +0000 if it is stringing, your filament might be wet.  I bought a warmer to cook it to get ride of the moisture.

]]> Assembly and first prints troubleshooting gzhangx https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/print-quality-was-good-but-not-any-more/#post-724441 Print quality was good, but not any more https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/print-quality-was-good-but-not-any-more/#post-723048 Fri, 27 Sep 2024 15:56:17 +0000 Hello everyone,

in the last two years the MK3+ works well an everthing was fine.

Recently I have been printing areas where filament is missing (hole in layers of the outer wall) and areas where there is too much filament.Parts that looked in the past great, now look miserable (nothing has been changed in the Gcode).

I have already replaced the nozzle, but that didn't help. The contact pressure of the extruder should also be correct. What else could it be? Straight geometries still look okay, but curved geometries can be thrown away. Unfortunately, I don't have any ideas.

Greetings Christoph

1

2

 

 

]]> Assembly and first prints troubleshooting Stoffel https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/print-quality-was-good-but-not-any-more/#post-723048