Notifications
Clear all
Print quality was good, but not any more
Hello everyone,
in the last two years the MK3+ works well an everthing was fine.
Recently I have been printing areas where filament is missing (hole in layers of the outer wall) and areas where there is too much filament.Parts that looked in the past great, now look miserable (nothing has been changed in the Gcode).
I have already replaced the nozzle, but that didn't help. The contact pressure of the extruder should also be correct. What else could it be? Straight geometries still look okay, but curved geometries can be thrown away. Unfortunately, I don't have any ideas.
Greetings Christoph
Posted : 27/09/2024 3:56 pm
RE: Print quality was good, but not any more
if it is stringing, your filament might be wet. I bought a warmer to cook it to get ride of the moisture.
Posted : 15/10/2024 3:26 am