Notifications
Clear all
Print issue with M3KS and PETG Superjet
Hi
Just received my printer a I had to recently redo my cal but the result is poor. The XYZ cal is ok and the 1st layer seems to be ok. The issue is that during the printing I get some pellet of PETG which lead to crush. It appears on some part of the print
The rest of the print seems to be ok.
Any idea to fix that issue ? I check in the typical troubleshooting bu I did not find my case. Thanks in advance
Posted : 03/06/2020 10:22 am
RE: Print issue with M3KS and PETG Superjet
IMHO there is not even one square inch looking even nearly decent. This is back-to-basic-calibration all the way.
Just my 2c
I try to give answers to the best of my ability, but I am not a 3D printing pro by any means, and anything you do you do at your own risk. BTW: I have no food for…
Posted : 03/06/2020 10:08 pm