Notifications
Clear all
Possible calibration issue with first layer
Attached is a photo of the bottom layer for a print that completes. This particular print came out very well having been done on the 200u FAST setting. The only thing I noticed was that the center of the first layer was inconsistent with the sides. The sides are all fully bonded with eachother while the center has some consistent gaps. Could this be an issue with my PINDA or other calibration settings?
Posted : 19/07/2018 3:33 am
Re: Possible calibration issue with first layer
You could try to play with the parameters of the "Bed Level Correction" section of the Calibration menu.
By the way, have you seen and read this thread: https://shop.prusa3d.com/forum/assembly-and-first-prints-troubleshooting-f62/life-adjust-z-my-way-t2981.html ?
Posted : 19/07/2018 10:57 pm