Notifications
Clear all
Obstacle detected.
Hello, I just assembled the Mk3s and on the first impression (puppy Buddy of the SD), the printer has made 4 or 5 stops, indicating on LCD "obstacle detected" and then resume without problems and finish the job with a Buddy 10 / 10 what might these stops be due to? excessive tension? Thanks in advance.
Posted : 31/07/2019 8:49 pm
RE: Obstacle detected.
The bed must move freely front to back, and the extruder side to side. Any sticky spots are bad.
Posted : 31/07/2019 9:41 pm