Noob first print, looks good to me...Is it?
Hi, just finished putting my kit together and ran my first print after doing all the calibration steps. I picked the triceratops skull as my first print not realizing it would take almost 6 hours! Oh well, my youngest granddaughter loves dinosaurs so the tri was really my only choice. Went to bed with fingers crossed.
Prusa PLA, settings as on SD card.
Re: Noob first print, looks good to me...Is it?
Looks quite good, perhaps a couple of strings...
lots of people have done worse with simpler models
have a look at the underside, if that is tidy, you have done well
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Re: Noob first print, looks good to me...Is it?
Looks quite good, perhaps a couple of strings...
lots of people have done worse with simpler models
have a look at the underside, if that is tidy, you have done well
regards Joan
Thanks, yes a little more cleanup is in order. Also here’s a pic of the backside.
