Notifications
Clear all
new kit, tuning my floaty boaty
Hi all,
I am sure you are tired of looking at this boat! First Print is out and was hoping you may give some advice to tuning my prints a bit better.
main issues i see are for example on the rear and the joins on the top funnel.
look forward to hearing from you and getting down with 3d printing.
thanks
Posted : 29/06/2020 10:12 am
RE: new kit, tuning my floaty boaty
Try tightening the belts and playing with retraction settings, it should all work out fine.
Posted : 30/06/2020 12:30 pm