Notifications
Clear all
New kit Build Prints have wavy layer shift.
I assembled my kit this weekend and was happy with the results of my flat first layer calibration. Unfortunately during testing a cube and benchy there is a bad wave in the parts. I have checked all of the belts(X255 Y262) and there connection points, everything appears tight without an obvious collisions. Any advice?
Posted : 20/12/2021 2:40 pm
Topic starter
answered:
RE: New kit Build Prints have wavy layer shift.
Flipped the pulley on my y axis to get a better alignment and it fixed the issue!
Posted : 21/12/2021 1:06 am