MK3 XYZ calibration fails after upgrading to firmware 3.9.3
Hi,
Prebuild MK3 printer
I just upgraded my printers firmware to the new 3.9.3 version and of course I wanted to test the new calibration process right away but it seems that there are some problems with the firmware.
I have made no hardware changes only downloaded the new firmware version and tried to do the XYZ calibration. Everything goes well until the last calibration point where the calibration fails with a error "Calibration point was not found". Calibration was successful every time on the old firmware.
Should I wait for a patch or just downgrade the firmware back to the old one?
RE: MK3 XYZ calibration fails after upgrading to firmware 3.9.3
I got this fixed myself...
Problem was between the chair and the keyboard. I downloaded MK3 firmware when I have the MK3S which the printer itself was kind enough to point out on startup.
RE: MK3 XYZ calibration fails after upgrading to firmware 3.9.3
@tonip
Thanks for the feedback! Interesting what the "S" can do. Anyway, good that your printer is up and running now!
happy printing 👍
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.