Notifications
Clear all

Micro Layer Shift, isn't it ?  

  RSS
Xuvin
(@xuvin)
New Member
Micro Layer Shift, isn't it ?

Hello guys,
I hope you can give me some advice.

Since I upgraded to the MK3, I am experiencing suddenly some weird lines. Mainly in the direction of the Y-axis (see image).

It even goes so far, that it results in kind of a layer shift.

Previously I also printed some nices looking prints (e.g. see pricture), before those named issues occured.

Can you help me ? 😀

Posted : 23/04/2018 7:08 pm
thrawn86
(@thrawn86)
Honorable Member
Re: Micro Layer Shift, isn't it ?

could be your y belt is skipping steps, or there is a tremendous amount of slack

Posted : 24/04/2018 5:22 am
Kwaad2
(@kwaad2)
Honorable Member
Re: Micro Layer Shift, isn't it ?

Check that the lock-screw on your Y axis pulley is tight.

Check what @curtis.c2 said.

Hi, I'm Sean. I used to work on CNC machines.
I try to not make mistakes, but the decision is YOURS.
Please feel free to donate to my filament/maintance fund.

Posted : 24/04/2018 6:33 am
Share: