Notifications
Clear all
Page 2 / 2
Prev
RE: Issues with Trapezoidal Nut
I also have the same issue but it looked like if I loosened the M3x18 screw on the right side just a little bit the lead screw easily spun. When I tighten the M3x18 screws tight, the lead screw would stop spinning. I took the Trapizoidal nut off the x-axis and twisted it onto the lead screw just fine, it was when it was screwed inside the x-axis I ran into problems. I wonder if it's "ok" to leave the screws a little loose? I have no idea this is my first build.
Posted : 15/05/2023 6:54 pm
RE: Issues with Trapezoidal Nut
I have a same problem after one year, see this video https://storage.googleapis.com/prusa3d-content-prod-14e8-wordpress-forum-prod/2024/02/68e29652-nutfriction.mp4
Posted : 02/02/2024 8:23 pm
Page 2 / 2
Prev