Notifications
Clear all
Is this bed leveling good?
Hi all,
My prusa mk3s has been very good for 2 years then recently start to having print issues.
Tried replace hotend etc, a bit better but still not good on first layer. Seems no matter how I adjust it, it is not level (i.e. I adjusted first layer calibration fine, but when printing the prusa 3x3 blocks, it seems the bed is not even).
But after getting Bed Level Visualizer, the bed looks fine. I am just not sure what are the normal range of the values for bed level, want to make sure I am not chasing ghosts. Thanks!
Posted : 17/10/2024 4:00 pm