I would like to raise the level of the intro line - Assembly and first prints troubleshooting https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/i-would-like-to-raise-the-level-of-the-intro-line/ Prusa3D Forum Discussion Board en-US Mon, 08 Jun 2026 18:06:14 +0000 wpForo 60 RE: I would like to raise the level of the intro line https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/i-would-like-to-raise-the-level-of-the-intro-line/#post-692697 Thu, 04 Jan 2024 19:17:38 +0000 Hi Kyle,

 

The way to do that would be to redo first layer calibration or you could adjust it in Prusa slicer.

 

Regards,

Rocket Printer

]]> Assembly and first prints troubleshooting Rocket printer https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/i-would-like-to-raise-the-level-of-the-intro-line/#post-692697 I would like to raise the level of the intro line https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/i-would-like-to-raise-the-level-of-the-intro-line/#post-688199 Thu, 07 Dec 2023 14:56:53 +0000 I was just curious what the easiest way would be to slightly raise the height of the intro line so it does not squish filament onto the top of the nozzle?

I have an mk3s.

]]> Assembly and first prints troubleshooting kyle k https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/i-would-like-to-raise-the-level-of-the-intro-line/#post-688199