Notifications
Clear all
Hotend / Nozzle not level.
I've been having a couple of issues I've been trying to troubleshoot (top layer infill at corners not looking good), and while looking into that I've noticed that my nozzle / hotend doesn't appear to be level with the heatbed. Looking at the nozzle from the front side of the printer, it appears to be tilted left a bit. I would post a picture, but it's very hard to get a picture where it's clear, but it's definitely tilted. Is there a good way to correct this and could this tilting result in any artifacts on my prints?
Thanks
Posted : 12/07/2020 1:15 pm