Notifications
Clear all

Got my MK3 kit together. How am I doing?  

  RSS
Byulos
(@byulos)
Active Member
Got my MK3 kit together. How am I doing?

Hello everyone,

This is my first 3D printer, and have no reference to compare my results against besides pictures online. I would greatly appreciate it if some of you could take a look to see what I can improve on. The only real issues I have noticed is the infill on a recent print that I stopped before completion, and the lines running across the top of the base on the Caesar; any ideas as to what could have caused them? Thank you all in advance.

Posted : 04/08/2018 11:10 pm
Rosparovac
(@rosparovac)
Estimable Member
Re: Got my MK3 kit together. How am I doing?

This prints are awesome.
The ceasar issue is that mid part printing first/last and lines are not connectet to each other. Two way to fix it:
1. Reduce fillament flow in slicer.
2. Try tu fine tuning of Z axis.

But as I said, your print are awesome and if this is out of the box printer setup you are lucky. I have to reasemble printer several times fix many problems to reach this beauty.

University: MK2S upgraded to MK3 with MMU2.0
Home: MK3
Materials: ABS; ASA; PETG; PET; PLA; Nylon; Nylon Carbon; CPE;
SW: Freecad 0.18; Slicer PE And still generating more troubles than whole forum together.

Posted : 05/08/2018 12:23 am
Share: