Notifications
Clear all
First Print needs a little help
Hello,
just built my printer and need a little help. All works well but when I did the first print of the prusa logo all the letters look like they have a nozzle mark in them. I calibrated everything to the best of my little knowledge. Im very new to 3d printing. Here is a picture.
Posted : 26/11/2018 10:28 pm
Re: First Print needs a little help
is that the supplied gcode on the sdcard?
i would address the underextrusion on the top layer first
https://www.simplify3d.com/support/print-quality-troubleshooting/
Posted : 27/11/2018 3:53 am
Re: First Print needs a little help
Hi Collin,
it's "Printer Settings -> Extruder 1 -> Retraction -> Wipe while retracting" - try to uncheck this and slice it with this setting.
Enabled "Wipe while retracting":
Disabled "Wipe while retracting":
Posted : 17/12/2018 3:27 pm