Notifications
Clear all
First Print, issue Sticking to Bed
Looking for a little assistance.
Last night finished build and calibration and am having issues with the prints sticking to the bed. Also it appears that there is not enough plastic being extruded? Any recommendations?
Thanks All!
Posted : 31/05/2018 1:00 pm
Re: First Print, issue Sticking to Bed
Your Z level is too high, which means that the filament does not attach to the bed. You do not specify which Z level you have, but try changing this -050 to -100 units and fine-tune Z level when it starts to look good. There are a lot of tips on the forum about this.
Bear MK3 with Bondtech extruder
Posted : 31/05/2018 2:35 pm