Notifications
Clear all
First layer test print feedback!
My 3D printer has been sitting in the corner of my room collecting dust yesterday I started to clean it and lubricate it calibrate it and tighten the belts and I think it is working great I am also using a steel nozzle instead of brass but I would like some feedback for the test print if you have any suggestions please feel free to comment!
Posted : 16/09/2024 3:44 pm
RE: First layer test print feedback!
Looks fine to me.
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Posted : 23/09/2024 11:58 am