English
Forums
English forum
Original Prusa i3 MK3 & MK3S & MK3S+
Assembly and first prints troubleshooting
First layer not sticking to bed
 
Notifications
Clear all

First layer not sticking to bed  

    Last Post
  RSS
ffdez
 ffdez
(@ffdez)
Active Member
First layer not sticking to bed

Hi. I did well on initial setup yesterday, Prusa logo print and an 11 hours Deli container prototype print. Today I wanted to print a 3-line golf marker (Thingiverse) and after 1-2 minutes the whole printed area unstick from bed. What am I supposed to do? 

Posted : 15/06/2021 12:18 am
cwbullet
 cwbullet
(@cwbullet)
Member
RE: First layer not sticking to bed

Welcome to the forum.  

Two most common reasons for unsticking prints:

 

  1. Dirty bed - clean with dish soap and water
  2. Z offset not perfect 

I would start with those two and you will find the problem.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 15/06/2021 11:11 am
Dan Rogers liked
ffdez
 ffdez
(@ffdez)
Active Member
Topic starter answered:
RE: First layer not sticking to bed

@cwbullet

Thanks. Solved.

Posted : 16/06/2021 1:14 am
ffdez
 ffdez
(@ffdez)
Active Member
Topic starter answered:
RE: First layer not sticking to bed

Thanks, solved

Posted : 16/06/2021 1:14 am
  All forum topics
  Previous Topic
Next Topic  
Share: