First layer call spikes in line
I have been printing with this setup for over a year
Last week something broke.
Things I have done, dry fillament clear bed, new nozzle, check for under extrusion,. Clean the fillament wheels, firmware update. Run first setup wizard , check belts, changed fillament, test pinda probe, and checked the PTFE tube,
I am at a loss. I am doing the first layer calibration and I get this.
Bet I am missing something:)
Best Answer by Caiman:
The issue was the fillament I got an bad baths the diameter fluctuates this causes higher and lower pressure therefore the spikes
RE: First layer call spikes in line
The issue was the fillament I got an bad baths the diameter fluctuates this causes higher and lower pressure therefore the spikes
RE: First layer call spikes in line
Thanks for letting us know Caiman.
I Hope you didn't get a lot of that particular filament.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK