First calibration help
Hello,
I just finished assembling my new Prusa i3 MK3, and completed the first guided calibration.
I tried to print two models already present on the SD card to verify that I had calibrated the printer correctly.
The models are: Batman logo and Buddy the dog.
Here are some photos of the two prints:
The models came very well, but I noticed some small imperfections.
The top of Buddy's head (where the print ends) is not perfect. Also some edges of the Batman logo (also visible in the base of a Buddy's foot).
Is this normal or can I improve the calibration to get a perfect print?
Do you have any advice on this? Can you help me?
Thank you very much!
Re: First calibration help
You could try variable layer height for the very top few layers
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK