Dim segment in the LCD display
Hi All,
I have finished building my MK3S and everything is going along nicely, except I have noticed that a couple of segments are dim on the LCD display. The first thing I did after completing the self tests & calibration is a firmware update to v3.7.0, but this didn't help. Is this a known issue, or do I have a faulty LCD display?
It was kind of difficult to photograph, but you can see here that the left segment of the left zero of the print speed percentage is dim. It's not visible in the picture, but the same segment in the line above has the same issue.
Thanks,
Matt
Best Answer by Matt:
Prusa Printers have confirmed that I have dead pixels in my LCD, they have already sent a replacement. 👍
RE: Dim segment in the LCD display
Prusa Printers have confirmed that I have dead pixels in my LCD, they have already sent a replacement. 👍