Curious about a noise - is it normal?
I just assembled my MK3S and everything seems to be fine. My Prusa logo print and Benchy came out nice (Except a little stringing on Benchy) but I noticed when the extruder moves all the way to the left in the very beginning it hits the orange piece on the z axis rods and I hear it. It’s like it runs in to it to stop moving left. It doesn’t do it again while printing but I was wondering if this is normal. Any ideas?
Thanks
RE: Curious about a noise - is it normal?
Here's a link to a video of the noises. It is in the very beginning before a print starts and also the bed seems to go all the way back and hit the frame. Thoughts? Thanks
RE: Curious about a noise - is it normal?
Totally normal. That's the printer finding the x-axis zero point. All part of the homing routine.
You'll notice that the bed does the same thing.
RE: Curious about a noise - is it normal?
@peter-k42
Thank you!