Notifications
Clear all
Page 3 / 3
Précédent
I have to get a new sheet because of it as it made humps on top of the sheet.
If these are small bubbles at the major stress points then they will go away naturally as you use the plate - just make sure to place the next print or two to avoid them. This issue is worst with a new print sheet and diminishes with time.
Cheerio,
Publié : 07/06/2023 7:56 pm
shawn.t3 a aimé
RE: Complete frustration with MK3 - first layer/print problems and it's about to become a boat anchor
I you chuck in the water, please unplug it and post a video!
--------------------
Chuck H
3D Printer Review Blog
Publié : 07/06/2023 10:52 pm
Page 3 / 3
Précédent