Notifications
Clear all
Calibration failure
Suddenly, after months of printing without any problem, my Mk3S showed a Z-calibration problem. Actually, I cant do anything to recalibrate the printer. With the latest firmware, trying to selftest or xyz calibrate, my extruder goes up to the top, then, when it has to go down to the print plate, it says only endstop Z wiring error. When I start the self test with the extruder not completely on the left, it says axis X length error. When I start with the extruder completely on the left, it begins a little bit to ascend, then very quickly stops and says enstops wiring error Z. Some tips to repair this?
Posted : 13/05/2023 4:33 pm