Notifications
Clear all
Bed level test print
Here is my bed level test print. It's looking to me that the rear to rear right is high. Is this what you folks are seeing? Is this enough to worry about? I've not really been having any print issues. I've had good prints with both PLA and PETG, though I am having a little issue with Z being on dimension.
Posted : 11/06/2021 9:03 pm
RE: Bed level test print
It's close, I think you can go a fraction lower judging by the centre.
Are you using 7x7 mesh-bed levelling?
Cheerio,
Posted : 11/06/2021 11:15 pm
Dan Rogers liked