Notifications
Clear all
Prusaslicer 2.3.1
Bonjour,
Pourquoi il n'y a pas de support généré en dessous de ma pièce? J'ai beau dire partout. J'ai beau faire des supports plein le résultat est toujours l'image d'en bas.
Merci.
Posted : 12/06/2021 7:47 pm
RE: Prusaslicer 2.3.1
Check and make sure you don't have "Don't support bridges" checked on the support material section. It's near the bottom of the list.
Ted
Posted : 12/06/2021 8:48 pm
1 people liked
Topic starter
answered:
RE: Prusaslicer 2.3.1
@technical-ted
Ok I got it" Thanks a lot
Posted : 12/06/2021 8:58 pm
1 people liked