Notifications
Clear all
How do I add a steel insert to a model?
I am creating a seal using TPE filament and at a certain point I need to add a steel washer then enclose it within the model.
How do I do this using the Prusaslicer?
Posted : 17/05/2023 4:22 pm
RE: How do I add a steel insert to a model?
some ideas in here
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Posted : 17/05/2023 5:25 pm
Topic starter
answered:
RE: How do I add a steel insert to a model?
Thanks Joan,
that is about how i figured it had to be done.
Ron
Posted : 18/05/2023 7:54 pm
RE: How do I add a steel insert to a model?
Happy Printing!
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Posted : 18/05/2023 8:34 pm