Need help with initial setup.
Recently purchased a MK3S ( assembled ) and went through the setup procedure. Now when starting the printer the display says the calibration is not complete, that it needs a 'Flow' calibration. I have gone through the first layer calibration twice but it still comes back.
Can anyone tell me where I need to go to run this test?
RE: Need help with initial setup.
contact prusa through live chat on their website they can guide you through it better then trouble shooting this on a forum
Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models
RE: Need help with initial setup.
It appears that the calibration wizard was not completely run, or a factory reset occurred.
Run the calibration wizard again.
Follow each step shown on the screen and complete the calibration wizard.
After that, you should be able to print without any error messages.
As a help the video of Josef.