Notifications
Clear all

Y stepper "jerking"  

Page 2 / 2
  RSS
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Y stepper "jerking"

Yeah, :geek: David :geek: is really good - he usually picks up the things I forget (and there are many).

Pleasure to assist.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 27/07/2016 10:59 pm
David T.
(@david-t)
Noble Member
Re: Y stepper "jerking"

Yeah, Peter is even better, usually answers 30 seconds faster than me. 😆 😎

Posted : 27/07/2016 11:04 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Y stepper "jerking"

Or in this case, 5 minutes... 😀

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 27/07/2016 11:16 pm
Jason Wood
(@jason-wood)
New Member
Re: Y stepper "jerking"

I had this same thing happen to me. Unplugging the Y motor and then back in fixed the problem. I must have jostled it loose when I had to fixed the front fan connection. Thanks for the suggestion! After correcting a little misalignment and the Y axis problem, I started my first print 11 hours after receiving the printer. This is to do in no small part to threads like this. Switching from the makerbot 5th gen was a good choice.

Posted : 22/01/2017 12:24 am
Page 2 / 2
Share: