Notifications
Clear all
Very cheap and better spool holder
This is a quick hack I did to get a better rotation of the filament spool.
I used the supplied cardboard tube (cylinder with the rods) with its 2 caps.
I just cut a section large enough to hold the spool, then removed the small wings around each cap and marked the diameter of the original holder on them.
Then cut the holes with a knife (slowly) and inserted them in the tube.
Job done. It's really smoother now.
Posted : 10/12/2017 8:19 pm
Topic starter
answered:
Re: Very cheap and better spool holder
Another photo of the tube in detail
Posted : 10/12/2017 8:25 pm