Notifications
Clear all

Stringiness on prints  

  RSS
panagiotis.k3
(@panagiotis-k3)
Active Member
Stringiness on prints

Hi again!

My PLA and PETG prints are suffering from stringiness.

For example these PET prints. I can probably accept this is due to incorrect Slic3r settings since I was using a third-party filament.


But the stringiness is also present on this pre-sliced Adalinda print. This is with the PLA filament that arrived with the printer (filamentum).


Online videos of Adalinda printing on MK2S do no show this problem. So this points at a problem with the printer? I have no idea what to check for. Both fans are working. I am using Silent Mode. I can not be 100% certain, but I think this problem has gotten slightly worse since I deassembled and reassembled the extruder to resolve a jam. On the the other hand I used a new pre-assembled hotend, so it should be as good as new.

Thanks for any advice! Best regards, Panos

Posted : 12/09/2017 8:42 am
henrik.w
(@henrik-w)
Estimable Member
Re: Stringiness on prints

Hello Panagiotis!

You have an excellent post here: http://shop.prusa3d.com/forum/original-prusa-i3-mk2-f23/come-to-the-dark-side-we-have-petg-t1952.html#p15304 .

Hopes that can solve your problem...

/Henrik

Posted : 12/09/2017 9:57 am
Share: