Notifications
Clear all
Overlapping Lines on infill layers
Hey there,
I got my prusa mk2s tuned in quite well and the prints usually turn out beautiful. However I noticed that when the printer fills up the layers it sometimes chooses to fill the whole area starting from different sections which are connected later. Sometimes this behavior leads to a small gap between adjacent areas which looks like 0,2mm width but is getting filled with the full Nozzle width. This results in a slight overlap.
I have attached a picture for better understanding.
Can this somehow be tuned? It usually is not noticeable in the finished print but it nags me a bit 😉
Cheers, Markus
Posted : 04/02/2018 5:19 pm
Re: Overlapping Lines on infill layers
RIP PEI sheet...
Posted : 04/02/2018 8:06 pm