Notifications
Clear all
Getting "Bed leveling too high" warning after one print.
I just did a single print now I'm getting the "bed levering failed. Sensor triggered too high. Waiting for reset" message. Is this a firmware issue or do i need to reconfigure after each print.
Posted : 05/11/2017 6:13 am
Topic starter
answered:
Re: Getting "Bed leveling too high" warning after one print.
Okay. So I tried using the original prusa filament. I managed to get two good prints after a full reconfiguration. The only problem is after the second reconfiguration it again gives me the same exact error there's nothing or at least doesn't appear to be anything wrong with the printhead or anything else. Is this a firmware issue or something?
Posted : 05/11/2017 5:13 pm