Notifications
Clear all

Calibration flow  

  RSS
Harrison Spain
(@harrison-spain)
Active Member
Calibration flow

Be gentle, first time poster. I've read and re-read the manual, but can't seem to get my printer to stop prompting me to Calibrate. Something about "Calibration flow".

I've done Z. I've done XYZ (a mistake I know since this was done at the factory). I've printed parts with limited success. I sure would like for the printer to get past this "calibration" issue. Do you really HAVE to print the Prusa logo to get past it?

Following the manual where factory built is interlaced with kit built can get confusing (at least to me) sorry!

Noew Prusa i3 MK2 printer owner

Harrison Spain
[email protected]

Posted : 03/06/2017 4:47 am
Harrison Spain
(@harrison-spain)
Active Member
Topic starter answered:
Re: Calibration flow

I found the answer; apparently there is some magic gcode in the V2Calibration.gcode file you MUST print to remove the calibration message.

Harrison Spain
[email protected]

Posted : 03/06/2017 6:46 am
Share: