Notifications
Clear all
Bubbly edges
Hi all,
As of late my printer puts this weird bubbly edges on the first layer of my prints. Can't exactly recall when it started happening, but it only does it on the first layer. All other layers appear to be fine. Any thoughts on where to begin looking to fix this? Any help would be greatly appreciated 😉
Posted : 09/12/2016 11:24 pm
Re: Bubbly edges
Over-extrusion.
You may fix it by raising live Z adjust slightly, or it may be a slicer setting.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Posted : 09/12/2016 11:31 pm