Notifications
Clear all

Broken x-carriage  

  RSS
Simon Miller
(@simon-miller)
Active Member
Broken x-carriage

So when replacing my belt I broke the tab where the belt loops around on the x-carriage. I went to print a replacement and lo and behold it looks different then the original. I was able to install the original but could not get the belt to go inside the slots. Also it looks like the wires will end up rubbing on the lower belt on this new version. Does any one have any experience with this? I searched the inter webs and couldn’t find anything.

Posted : 20/12/2017 1:55 pm
GertL
(@gertl)
Reputable Member
Re: Broken x-carriage

Isnt the top one for MK3 ?

---
Gert

Posted : 20/12/2017 2:11 pm
Simon Miller
(@simon-miller)
Active Member
Topic starter answered:
Re: Broken x-carriage

The version on the left is the one that came with my mk2 and the version on the right is the one that is on The Prusa site listed under mk2.

Posted : 20/12/2017 9:39 pm
alexander.s27
(@alexander-s27)
Estimable Member
Re: Broken x-carriage

No idea whats Left or right here. The One with the teeth is not for the mk2s. And the One whats actual available unser mk2s These minutes is the One without teeth.

Posted : 20/12/2017 9:54 pm
GertL
(@gertl)
Reputable Member
Re: Broken x-carriage

I downloaded the MK2S parts now, below is x-carriage
From where did you download yours?

---
Gert

Posted : 21/12/2017 8:39 am
Share: