Notifications
Clear all
Under Extrusion or something else
Hi All
I am having a problem lateley with my prints i am getting wierd artifacts on the top surfaces of my prints attached is an sample image. Any advise, is this underextrusion or is it some thing else.
Keep on smiling -
Posted : 14/08/2017 8:59 am
Re: Under Extrusion or something else
There does look to be under extrusion present there, but there are also quite a few other issues as well.
I think you should try a pre-sliced print to see how that turns out.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Posted : 14/08/2017 9:38 am