Notifications
Clear all
MK2 to MK2S, and then MM
Hey
Do i need to print any of the parts to upgrade my MK2 to MK2S, if i want to upgrade my printer with the multi material immediately afterwards?
Publié : 30/06/2017 10:03 pm
Re: MK2 to MK2S, and then MM
Yes. You certainly need the rear extruder and cable support to improve cable management.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Publié : 30/06/2017 10:35 pm