English
Forums
English forum
Original Prusa i3 MK2/S Multi Material
Assembly and first prints troubleshooting
Left plastic part after MMU2s assembly
 
Notifications
Clear all

Left plastic part after MMU2s assembly  

    Last Post
  RSS
Sir Kruppos
 Sir Kruppos
(@sir-kruppos)
Active Member
Left plastic part after MMU2s assembly

Hi there,

i just finished the assembly of my Mmu2s onto my Mk3s and in the process of cleaning up afterwards I noticed this piece. I can’t remember taking it off or out of a bag. Can you tell from the picture where it belongs?

 

Thanks,

Posted : 23/08/2019 8:35 pm
Lichtjaeger
 Lichtjaeger
(@lichtjaeger)
Noble Member
RE: Left plastic part after MMU2s assembly

This part is only needed for the MK2.5S.

Posted : 23/08/2019 9:45 pm
Sir Kruppos
 Sir Kruppos
(@sir-kruppos)
Active Member
Topic starter answered:
RE: Left plastic part after MMU2s assembly

Thanks! Good to hear I don’t have to take anything apart 😂

Posted : 24/08/2019 6:50 am
  All forum topics
  Previous Topic
Next Topic  
Share: