Notifications
Clear all
bridging problems
Hi,
after updating the firmware on my i3 mk2s, I started getting quite ugly bridges on ABS prints:
I've tried a few different settings in the slicer, from the "Detect Bridging Perimeters" option to trying to increase and decrease print speeds for the bridges, to printing with supports, which seems to stabilize the parts, where they do fit, but there's parts, where they don't really fit and even when they do, they're hard to remove.
With the older slicer and older firmware, I was able to print the same model without supports though.
Does anyone have any idea what else I could try to get this to print correctly without supports?
Cheers,
Ivan
Posted : 05/03/2020 9:55 am