Notifications
Clear all
Z motor moves down as I move Y-axis back
After 40 days or so of printing it stopped with a failed to trigger message. I tried running a Z calibration and from point 4-9 it pushed the bed down. I couldn't figure it out for the longest and tried over and over until I noticed when going to settings and moving various axis around to see where it was on the bed at different points, I noticed that as i moved the y-axis back (bed forwards) the z motor was turning and lowering the nozzle closer to the bed the further I went positive (move bed towards front) and the nozzle would begin hitting the bed at about the middle. What's causing this?
Posted : 18/02/2017 8:19 am