Notifications
Clear all
Won't power up -- fuses are OK
Hi Everyone,
My printer went black during a calibration cycle and wont' turn on.
-- The fuses all seem OK (3 on Rambo, 1 on Power Supply)
-- I don't see any LEDs on the board or power supply (but I don't know where to look specifically)
Can anyone help me figure out what to do next? I'd LOVE to get my printer working again : )
Posted : 21/09/2018 8:25 pm
Re: Won't power up -- fuses are OK
Do you have a multimeter ?
Check if your input voltage to the RAMBO is 12V.
Thomas
Posted : 24/09/2018 9:19 am