Notifications
Clear all
Resuming paused print, hotend setpoint = 0.
Hi,
I'm running a Prusa i3 MK2/S. Firm Ware version: 3.2.3. Prusa slic3er 2.4.1 or Cura 4.12.1. Only use SD card.
Recently there i have had three consecutive prints unable to resume after pausing an hour into printing. I pause the print from LCD menu, inspect it or change the filament spool. When i resume the print the hotend setpoint is 0. If i preheat hotend and the resume the setpoint goes to 0. If resume and then preheat the hotend, the print will resume at the "pause idle height" (a few centimeter above the actual print)
Any ideas?
This topic was modified 13 hours ago by Adam Rönngren
Posted : 10/01/2025 6:21 pm