Prusa MK2s Fails Calibration on Pt 2
Hi,
just took my old mk2s back from a nephew and as it was not printing and he asked me to take a look at it. I am runnign an MK3 now and building a second one.
The bed on the MK2S was hacked up pretty bad and I replaced it and ran a self test. All good. But moving onto the first calibration test, it calibrates the first point with a piece of paper which is the mid-point in the first row of sensors. It then moves onto the second point which is the far point in the second row and will not calibrate. I shut off power as it was dragging the paper back and forth.
I checked the firmware and it is 3.1 and at this point I am at a loss as to how to continue..
Any ideas woould be welcome..
Regards
Gary
Re: Prusa MK2s Fails Calibration on Pt 2
Never mind .. Pinda probe was off enought to cause problem.. Good 1/4 of an inch off.. All better now ..
Onto next test ..
G.,