Notifications
Clear all
Need to run Wizard before 1st layer calibration?
I'm hoping someone from Prusa chimes in on this.
The"Wizard does a lot of calibrations, including some that *I think* are along the z-axis. So is it necessary (or advantageous) o run it before doing a 1st Layer calibration?
Posted : 27/07/2021 11:30 pm
chat
If you trying to get an official response, it is probably better to use the chat. This is primarily a users forum.
--------------------
Chuck H
3D Printer Review Blog
Posted : 28/07/2021 2:52 am