Notifications
Clear all
Layer height issue after missing gear screw
Hello, a few months back my MK2S the locking screw in the extruding gear backed itself out and was lost. I replaced the screw and now when I print, it will lay down around 4cm of good filament, and then it turns into a stream the size of a thread. Very odd. Full calibration was done multiple times including the first layer. I adjusted the tension screws. The same thing happens every time. I suspected that maybe the screw fell down into the tube but I would have expected a full block. I am out of ideas and was wondering if anyone had any suggestions. Thanks!
Posted : 30/07/2020 3:28 am