Notifications
Clear all
Calibration Failure
So I recently moved my Mk2s and updated the firmware etc etc and decided I should probably make sure all is well with the calibration.... This was a Mistake!
It goes through the first 4 point calibration fine. When it goes through the improved accuracy 9 point calibration it is grabbing the paper on point 8 (rear middle) and trying to drive the head through the bed on point 9 (rear right). I don't understand what is going on. The error message showing is Calibration point not found.
Before this it had been printing fine so now I wish I'd never touched it....
Edit: I fear I may have wrecked my bed as well, as it has a nice big groove scored in it by the nozzle
This topic was modified 5 years ago by Xye
Posted : 21/04/2020 3:26 pm