Notifications
Clear all
PLA Printing issue
Hi,
I recently upgraded my 2S to a 2.5S and am now having issues printing PLA. After an hour of two of good printing (i.e. 1-cm height), I get separation as seen in the image below.
The print calibrates fine, and I've PID tuned the nozzle temp. I've tried it with and without the enclosure and increasing the nozzle temp 5 Deg C.
Any other ideas would be appreciated...
Attachment removed
Best Answer by paul.m19:
Got it worked out, but not sure what did it. Re-tensioned all the belts, re-seated the grub screws on the motor cogs and re did all the calibrations and it seems happy again...
Posted : 23/06/2019 10:25 am
Topic starter
answered:
RE: PLA Printing issue
Got it worked out, but not sure what did it. Re-tensioned all the belts, re-seated the grub screws on the motor cogs and re did all the calibrations and it seems happy again...
Posted : 24/06/2019 6:12 am